Monday, December 21, 2009

Whirlpool Wash machine ghw9400 Error code FDL/F11 HELP!?

My wash machine had this error code/problem like clockwork at the end of the warranty period, within days. During troubleshooting research online, I found the following from a repair tech leaving information on epinion: ';Quite simply, it is a door lock relay on the master control board (MCB). The MCB is located at the top of the machine below the top decklid. The most common fix if under warranty is to replace the MCB provided the tech can locate where the problem originates. Otherwise, the out-of-warranty MCB replacement cost about $200 - $250 to replace. The relay causing this problem is a $1.25 part and can be replaced in about 30min';





Whirlpool was pretty short with me, not wanting to help. Does anyone have any suggestions, found other scrap parts from models that are equivalent, or ANYTHING that may help? If I can get a hold of the component, I am sure someone I know can fix it. Even the schematic would help. Thanks! So much for buying number one ranked by consumer reportsWhirlpool Wash machine ghw9400 Error code FDL/F11 HELP!?
fdl indicates an overloaded washer. Make sure the door is closed firmly and the laundry isn't pushing too hard on the door.


the other, f11 or fH indicates a water problem. Make sure that both water valves are on and nobody is taking a shower which would lower water pressure below 10 psi.





to clear the codes and try again, push clear/cancel twice.

No comments:

Post a Comment